The ground cleaning
We adopt special stone cleaning agent, through the water, to cleaning, served with special machine scrub brush, to avoid excess infiltration water end, should be timely with absorb sewage suction machine, blot.
The ground is dry
-
End juncture place to have water damage, we use the water absorption machine blot, fully dry.
-
Other flat dry moisture use dry machine, more than individual water to clean with a dry towel.
Hemp pit crack decontamination
There are a lot of stone material surface due to wear or weathering has the small gravel, plus during mixed with black spots.For this kind of phenomenon must use special marble stone tools to these small gravel along with black stains take off.Then after take off stains with brush to clean up the holes.
Note: when remove stains to be especially careful, don't be cut around the surface of the stone.
Fill the pockmark alcoves cleft repair scheme
Fill the alcoves - fill the alcoves solution for stone water seepage is an important protective measures, must pay attention to caulking work, fill material should be a good bonding effect, no powder, waterproof, grinding and polishing, fill the technology as the first old caulking agent winkles, and clean clean will crack, and then caulking (flat) fill surface with stone material surface evenly, prevent omissions, and after two hours of drying curing.
Polishing grinding leveling
-
Choose a stone refurbished machines equipped with water tank.
-
To start the renovation machine, put the right amount of water, with the rough diamond pad the end first draw with, and to remove surface stains.
-
Leveling stones cut the height difference between mouth, in order to ensure that later crystal formation, must according to the shape of the "ten" when grinding with order.
-
With ideal effect change again after making a finer diamond pad, each increasing series, of stone material surface polishing is not less than twice, grind to the surface is smooth and bright.
-
Until the finest diamond pad, at this moment if feel stone material surface smooth, delicate degree to achieve the ideal standard, is to stop grinding.
Note: the above steps are done under the condition of the water, in order to prevent excessive water seeping into the stone, immediately with water absorption machine to absorb water.
-
Turn off the water tank, choose special polishing diamond pad for polishing.
Stone material surface protective treatment
-
In order to prevent stone material surface rusty spot, water spots and macular emerge in the future, delay the ageing of the stone, and improve the life of the stone must be for protection of stone material.
-
My company can use nanometer stone curing agent, the curing agent can effectively penetrate, stone material surface without leaving any trace, don't change the color of the stone, not affect the air permeability, stone and stone chemical bonding force is strong, has good aging resistance and wear resistance, good surface painting, has a strong and waterproof, anti-fouling, seepage control function.
-
① after leveling of stone material surface is clean and dry thoroughly with suction machine.
② after the protective agent to divide evenly, use the method of spray, painting, brush evenly in the stone material surface completely wet, so as to ensure the effective deep inside the stone protective agent.
③ if large stone water imbibition, 5-10 minutes for the second time protection processing, to ensure that the best protection effect, if small stone water imbibition, 20 minutes after wipe away excess protective agent of stone material surface, otherwise, may leave traces.
④ After finish coating protective agent, then try to avoid trampling, stone material surface, otherwise it will pollution to wait for natural stone material surface dry,
Crystallization process
-
Crystallization processing is heated through mechanical chemical enrichment and compressed into crystalline film spread on the ground of a process, it can be on the ground to form a layer of transparent colorless film, this process can remove the bacteria in pores, and make the ground after the last layer coating more smooth, lights, at the same time guarantee the end is not corroded by bacteria or dirt, also not be the sole stone grain damage.
-
According to the chemical composition of stone material and appearance is different, we should adopt different crystallization agent.
